This will only adjust the display time on the programmer. .

To adjust the NORMAL DAY bell times click here

To adjust the INTERVIEWS bell times click here

‍

Adjust the display time

‍

1. Open the LATCH below the screen
2. PRESS and HOLD the TIME ADJ (10) button until the small clock icon appears on the screen
3. Release the TIME ADJ (10) button. You are now in the mode to adjust the Hour/Minute/Day
4. Choose the desired HOUR time by pressing the H (5) button.

‍

IMPORTANT : Ensure you select the correct AM/PM or 24 hour time. To switch between AM/PM/24 Hour formats refer to the next section

‍

5. Choose the desired MINUTE time by pressing the M (4) button
6. Choose the desired DAY of the week by pressing the correct DAY KEY (13) button
7. Once you are happy with the selected HOUR/MINUTE/DAY press the WRITE (3) button to save these changes
8. Close the LATCH. Your display time has now been adjusted

Switching between 12hr and 24hr display time

We recommend that you set your AutoBell in the 24-hour display format. It is easier to make mistakes when reprogramming modes in the AM/PM format.

Instructions

1. Ensure that the MODE SWITCH (1) is on the RUN mode
2. Press the H (5) button for 2 seconds or more
3. This will switch the current time between the 12-hour (am/pm) and 24-hour display

‍

‍